LG LD-1481W4 Manuel d'utilisateur télécharger pdf (Page 10)

• This dishwasher may be fed with either hot or

cold water. If the water can not be maintained

below 65ºC, the dishwasher must be connected

to cold water.

• When connecting, you may use sealant tape or

sealing compound to avoid water leaks.

• Make sure that the line is not kinked or sharply

bent.

• It is recommended that the new inlet hose be

used and not an existing or old hose.

Final check and assembling

1. Securely hand tighten supply hose to the

water supply.

Plug the power supply cord into an earthed

electrical point and switch on after having

turned on the circuit breaker.

2. After installing and prior to using the

dishwasher with crockery, we recommend that

you use the dishwasher on Quick mode to

rinse through. At this stage it is useful to

ensure that there are no operating problems or

water leaks.

When the dishwasher is used for the first time,

there may be a loud noise, if this happens, turn

off the power and restart the dishwasher.

After installing the dishwasher, you may notice a

slight sticking of the door to the dishwasher,

when you open or close the door. If this does

happen you need to adjust the level of the

dishwasher.

• If the door slants to the right, see fig. C follow

these instructions:

1) Unscrew(counter-clockwise) the left leg of

the back side and correct the level.

2) Check the opening of door and repeat if

necessary until the door opens and closes

properly.

• When the product is correctly leveled, there

should be no slant, stickiness or rubbing sound.

Fig. C

Case 1. In case the door is slanted to the right

• If the door slants to the left, see fig. D follow

these instructions:

1) Check the opening of the door to hear if

there is a sticking or rubbing sound.

2) Check the opening of door and repeat if

necessary until the door opens and closes

properly.

• When the product is correctly leveled, there

should be no slant, stickiness or rubbing sound.

Fig. D

Case 2. In case the door is slanted to the left

Water tap

Fig. A

Fig. B

Some models consist of an inlet valve combined

with a hose. (Fig. A)

Connect the water supply hose to the water tap.

(Fig. B)

After connecting the inlet hose to the tap, turn on

the tap to flush out foreign substances (dirt, sand

or sawdust) in the water lines. Let water drain into

a bucket, and check the water temperature.

Connect the supply hose to the water inlet valve.

INSTALLATION INSTRUCTIONS

Installation of water inlet hose How to level the dishwasher

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

LG LD-1481W4 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle LG LD-1481W4