LG LA120HSV5 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 62
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Figure 3: Single Zone Art Cool Mirror Wall Mount Indoor Unit.
Due to our policy of continuous product innovation, some specications may change without notication.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
8 | PRODUCT DATA
Single Zone Art Cool
TM
Mirror Wall Mount Engineering Manual
General
LG Single Zone Art Cool Mirror Wall Mount systems are comprised of
a single outdoor unit connected to a single indoor unit with a single
refrigerant circuit.
These single zone systems can operate in either cooling or heat-
ing mode. These systems are capable of changing mode within a
maximum time of three (3) minutes to ensure temperature can be
properly maintained.
LG Single Zone Art Cool Mirror systems are manufactured in a
facility registered to ISO 9001 and ISO 14001, which is a set of
standards applying to environmental protection set by the Interna-
tional Organization for Standardization (ISO). The units are listed by
Intertek Electrical Testing Laboratories (ETL) and bear the ETL label.
Wiring in these units are in accordance with the National Electrical
Code (NEC).
Temperature Ranges
Outdoor Unit
Operating ranges for outdoor units of 14°F to 118°F DB for cooling
and -4°F to +65°F WB for heating.
Indoor Unit
Operating ranges for indoor units of 53°F to 75°F WB for cooling and
60°F to 86°F DB for heating.
Installing an optional Low Ambient Wind Baffle Kit will allow opera-
tion down to 0°F in cooling mode for these single zone systems.
Casing / Frame
Outdoor unit is constructed with pre-coated metal (PCM). Indoor unit
is constructed of heavy duty Acrylonitrile Butadiene Styrene (ABS)
and High Impact Polystyrene (HIPS) plastic.
Refrigerant System
The refrigeration system consists of a single refrigeration circuit and
uses R410A refrigerant. The outdoor unit is provided with factory
installed components, including a refrigerant strainer, four-way re-
versing valve, electronic controlled expansion valve (EEV), high and
low side charging ports, service valves, and interconnecting piping.
Refrigeration Oil Control
Heat pump outdoor units have a centrifugal oil separator and con-
trols to ensure sufficient oil supply is maintained, and that oil does
not travel with the refrigerant.
Compressors
The outdoor unit is equipped with one hermetic digitally controlled
inverter driven twin rotary compressor to modulate capacity (modula-
tion in 1 Hz increments). Frequency ranges for the outdoor units are:
LSU090HSV5 = 10-84 Hz
LSU120HSV5 = 10-92 Hz
LSU180HSV5 = 10-93 Hz
LAU240HSV3 = 10-100 Hz
Overcurrent protection and vibration isolation are integrated with the
compressor.
Outdoor Unit Coil
Heat pump outdoor unit coils are made of a nonferrous construction
with louvered fins on copper tubing, and are protected with an inte-
gral coil guard. Coil fans have a factory applied corrosion resistant
GoldFin
TM
material with hydrophilic coating.
Drain pan heaters are also available for the outdoor units. 9,000 and
12,000 Btu/h outdoor units include a factory-installed drain pan heat-
er. The drain pan heater for 18,000 and 24,000 Btu/h outdoor units is
offered as an optional accessory.
Fans and Motors
The outdoor unit includes one direct fan drive, variable speed pro-
peller type fan. The Brushless Digitally Controlled (BLDC) fan motor
shall have inherent protection, permanently lubricated bearings, and
variable speed with a maximum speed up to 950 rpm. Raised guards
are provided to limit contact with moving parts.
The outdoor unit has horizontal discharge airflow.
Electrical
These units are available in 208-230V, 60 Hz, 1-phase power supply.
These units are capable of operating within voltage limits of ± 10%
rated voltage, and include overcurrent protection.
Controls
The indoor unit casing has a factory-standard, integral infrared
sensor designed to communicate with the supplied LG wireless
handheld remote controller. An optional LG supplied wired controller
is available as an additional accessory. Communication between the
indoor unit and the outdoor unit is accomplished through 18 AWG,
four-core, stranded and shielded power/communication cable.
HSV5 indoor units have built-in Wi-Fi and can be controlled by LG’s
SmartThinQ™ app on a smartphone. A field-supplied Wi-Fi network
and smart device are required. The SmartThinQ app is free and is
available for Android™ and iOS.
Android is a trademark of Google LLC.
MECHANICAL SPECIFICATIONS
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 61 62

Commentaires sur ces manuels

Pas de commentaire