LG SH5B Manuel d'utilisateur télécharger pdf (Page 13)

Connecting 13

Connecting

Manually pairing wireless subwoofer

When your connection is not completed, you can

check red LED or blinking green LED on the wireless

subwoofer and the wireless subwoofer does not

make sound. To solve the problem, follow the steps

below.

1. Adjust volume level of the main unit to minimum.

- ”MIN” appears on the display window.

2. Press and hold (Mute) on the remote control

for about 3 seconds.

- “SUB-WF RESET” appears on the display

window.

3. Press and hold Pairing on the back of the wireless

subwoofer for more than 5 seconds.

- The LED of the wireless subwoofer lights up

alternately in red and green.

4. Disconnect and reconnect power cord of the main

unit and the wireless subwoofer.

5. Turn on the main unit. : The sound bar and

wireless subwoofer will be automatically

connected.

- Green LED on the rear of wireless subwoofer

turns on.

It takes a few seconds (and may take longer)

for the main unit and the subwoofer to

communicate with each other and make

sounds.

The closer the main unit and the subwoofer,

the better sound quality. It is recommended

to install the main unit and the subwoofer as

close as possible and avoid the cases below.

- There is a obstacle between the main unit

and the subwoofer.

- There is a device using same frequency

with this wireless connection such as

a medical equipment, a microwave or a

wireless LAN device.

Note

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Pas de commentaire

LG SH5B Manuel d'utilisateur Page 13