LG DLGX5001V Manuel du propriétaire télécharger pdf (Page 20)

Installing the Side Vent Kit

WARNING

t6TFBIFBWZNFUBMWFOU

t%POPUVTFQMBTUJDPSUIJOGPJMEVDU

t$MFBOPMEEVDUTCFGPSFJOTUBMMJOHUIJTESZFS

t5PSFEVDFUIFSJTLPGJOKVSZUPQFSTPOTBEIFSFUPBMM

JOEVTUSZSFDPNNFOEFETBGFUZQSPDFEVSFTJODMVEJOH

UIFVTFPGMPOHTMFFWFEHMPWFTBOETBGFUZHMBTTFT

t'BJMVSFUPGPMMPXBMMPGUIFTBGFUZXBSOJOHTJOUIJT

manual could result in property damage, injury to

persons, or death.

Your new dryer is shipped to vent to the rear.

It can also be configured to vent to the bottom or side

(right-side venting is not available on gas models).

An adapter kit, part number &&-#, may be

purchased from an LG retailer. This kit contains the

necessary duct components to change the dryer vent

location.

1. Remove the rear exhaust duct retaining screw. Pull

out the exhaust duct.

OPTION 1: SIDE VENTING

2. Press the tabs on the knockout and carefully remove

the knockout for the desired vent opening (right-

side venting is not available on gas models). Press the

adapter duct onto the blower housing and secure to

the base of the dryer as shown.

3. Preassemble a 4-inch (10.2 cm) elbow to the next

4-inch (10.2 cm) duct section, and secure all joints

XJUIEVDUUBQF#FTVSFUIBUUIFNBMFFOEPGUIFFMCPX

faces AWAY from the dryer. Insert the elbow/duct

assembly through the side opening and press it onto

the adapter duct. Secure it in place with duct tape.

#FTVSFUIBUUIFNBMFFOEPGUIFEVDUQSPUSVEFT

inches (3.8 cm) to connect the remaining ductwork.

Attach the cover plate to the back of the dryer with

the included screw.

OPTION 2: BOTTOM VENTING

2. Press the adapter duct onto the blower housing and

secure it to the base of the dryer as shown.

3. Insert the 4-inch (10.2 cm) elbow through the rear

PQFOJOHBOEQSFTTJUPOUPUIFBEBQUFSEVDU#FTVSF

that the male end of the elbow faces down through

the hole in the bottom of the dryer. Secure it in place

with duct tape.

Attach the cover plate to the back of the dryer with

the included screw.

Rear

Exhaust Duct

Retaining

Screw

Elbow

Cover

Plate

,OPDLPVU

#SBDLFU

Adapter

Duct

#SBDLFU

Adapter

Duct

Elbow

Cover

Plate

2/4

”

(3.8 cm)

INSTALLATION

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

LG DLGX5001V Manuel du propriétaire Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs à tambour LG DLGX5001V