LG BIDLGH Manuel d'utilisateur télécharger pdf (Page 8)

Instructions for the installer

4. GAS CONNECTION

Connection to the gas mains may be made with a rigid copper pipe

or with a flexible pipe and conforming to the provisions defined by

standard regulations in force.

To facilitate connection, fitting A on the rear

of the appliance may be adjusted laterally.

For this purpose, loosen hexagon nut B,

turn fitting A to the desired position, and

retighten hexagon nut B. Use a soapy

solution to check for proper tightness.

Never use a free flame.

The hob has been inspected for LPG G30/G31 at a pressure of

28-37 mbar. For use with other types of gases, see Section “5.

ADAPTATION TO DIFFERENT TYPES OF GAS”. The gas intake

fitting is ½ gas external threaded (ISO 228-1).

Connection with a flexible steel hose:

Make the connection to the gas mains using a

continuous wall flexible steel pipewhose

specifications comply with the applicable standard.

Carefully screw the connector 3 to the appliance’s

gas connector 1 (1/2” thread ISO228-1), placing

the seal 2 between them.

Connection with a flexible steel hose with

conical fitting:

Make the connection to the gas mains using a

continuous wall flexible steel pipewhose

specifications comply with the applicable standard.

Carefully screw the connector 3 to the appliance’s

gas connector 1 (½” thread ISO228-1), placing the

seal 2 between them. Apply insulating material to

the thread ofthe connector 3, and then tighten the

flexible steel pipe 4 to the connector 3.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

LG BIDLGH Manuel d'utilisateur Page 8