LG KA30010S Manuel d'utilisateur télécharger pdf (Page 17)

Safety Instructions for the Installer

• A device must be provided in the electrical installation which

allows the appliance to be disconnected from the mains at all

poles with a contact opening width of at least 3 mm Suitable

isolation devices include line protecting cut-outs, fuses (screw

type fuses are to be removed from the holder), earth leakage trips

and contactors.

• In respect of re protection, this appliance corresponds to type

Y (IEC 60335-2-6). Only this type of appliance may be

installed with a high cupboard or wall on one side.

• Drawers may not be tted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is tted must satisfy the

stability requirements of IEC 68930.

• For protection against moisture, all cut surfaces are to be sealed

with a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits

must be completely lled with grout.

• On natural, articial stone, or ceramic tops, the snap action springs

must be bonded in place with a suitable articial resin or mixed

adhesive.

• Ensure that the seal is correctly seated against the work surface

without any gaps. Additional silicon sealant must not be applied;

this would make removal more difcult when servicing.

• The hob must be pressed out from below when removed.

• Clean the work surface in the area of the cut-out.

• Sealing tape is mounted on the ceramic glass initially.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

LG KA30010S Manuel d'utilisateur Page 17