LG WD14030FD6 Manuel d'utilisateur télécharger pdf (Page 37)

37

Troubleshooting guide

Symptom Possible Cause Solution

• Water supply is not adequate in area.

• Water supply taps are not completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are clogged.

• Drain hose is kinked or clogged.

• The drain filter is clogged.

• Load is too small.

• Load is out of balance.

• The appliance has an imbalance detection

and correction system. If individual heavy

articles are loaded (ex. bath mat, bath robe,

etc.) this system may stop spinning or even

interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of

the cycle, add smaller articles of laundry to

balance the load and repeat the spin cycle.

• Ensure door is not open.

• Water overfills due to the faulty water

valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• The washer experienced a power failure.

• Water leaks.

• Check water supply.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose.

Clean and straighten the drain hose.

Clean the drain filter.

Add 1 or 2 similar items to help

balance the load.

Rearrange load to allow proper

spinning.

Close the door completely.

󳀌If “ ” is not released, call for

service.

Unplug the power plug and call for

service.

Close the water tap.

Unplug the power plug.

Call for service.

Allow the washer to stand for 30

minutes to allow the motor to cool;

then restart the cycle.

Restart the cycle.

Call for service.

Turn the tap on. If “ ” is not

released, unplug power plug and call

for service.

 Error Messages

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire