LG VR6170LVM Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
15
HOW TO START AND STOP CLEANING
After the HOM-BOT 2.0 is turned on, press the START/STOP button
to begin cleaning. A melody will sound and cleaning will begin.
Press the START/STOP button during the cleaning cycle to stop
cleaning.
When the ‘START/STOP’ button is pressed while the power supply
of the HOM-BOT 2.0 is turned off, the power will be turned on.
Press the ‘START/STOP’ button one more time to start cleaning.
After the HOM-BOT 2.0 is turned on, press the START button on the
remote control. A melody will sound and cleaning will begin.
Press the STOP button during the cleaning cycle to stop cleaning.
The HOM-BOT 2.0 cannot be turned on from Stand By, by using
the remote control when the power of the HOM-BOT 2.0 is off.
When the power is off, press the ‘START/STOP’ button on the
upper side of HOM-BOT 2.0 to turn the power on and to allow the
remote to be used.
During cleaning, collisions can happen when the sensor cannot detect objects because of their shape (Thin
chair and table leg, furniture corner). When this happens, the internal impact detecting sensor will avoid
the obstacles by using a backward motion.
If the HOM-BOT 2.0 is set to start cleaning at a location away from the home station, put the device on
a flat floor in order to prevent a malfunction of the obstacle detecting sensor. In addition, start cleaning
from a location where there are not any obstacles such as curtains or walls within 30 cm (11.8 in) of the
HOM-BOT 2.0.
For best results:
Briefly scan the area to be cleaned for big and small objects that will cause difficulty for the
HOM-BOT 2.0.
If cleaning is started when the HOM-BOT 2.0 is at the home station, the device can rapidly
be returned to the home station as the current home position has been accurately read.
For the safety of the HOM-BOT 2.0, a threshold of more than 10mm (0.4 in) cannot be
crossed.
When the rag plate is installed, to prevent the 2
nd
contamination by the contaminated rag, it
cannot go over door sill of 5mm or higher.
Using the buttons on the HOM-BOT 2.0
Using the remote control
Tip
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Commentaires sur ces manuels

Pas de commentaire