LG VR6170LVM Manuel d'utilisateur télécharger pdf (Page 25)

CLEANING THE DUST BIN

1. Open the dust bin cover by pressing the PUSH

button on the HOM-BOT 2.0.

2. Grab the handle of the dust bin and pull it

upward.

3. Separate the HEPA ﬁlter and the inside sponge

ﬁlter by removing the HEPA ﬁlter

※

To clean the dust bin lter, refer to page 24.

4. Lift the cover upward while pressing the

separation button on the dust bin.

5. Empty the dust bin and clean it with a cleaning

brush or under running water.

6. After cleaning with water, completely dry the

dust bin in a well-ventilated area out of the direct

sunlight.

7. When you have completed cleaning the dust bin,

close the cover and replace the sponge ﬁlter and

HEPA ﬁlter.

8. Put the dust bin into the HOM-BOT 2.0 and

close the dust bin cover.

If the dust bin is full, suction power can be weakened. Clean the dust bin before and after each cleaning

session. Clean the dust bin using the following sequence:

• After cleaning, always mount the dust bin filters (HEPA filter, sponge filter) to the dust bin.

If they are not mounted, dust may enter the HOM-BOT 2.0 interior and cause product failure.

• After cleaning the dust bin, make sure to start the operation with the dust bin installed.

If it is operated without the dust bin, voice message, “please check the dust bin” will sound.

Tip

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Pas de commentaire

LG VR6170LVM Manuel d'utilisateur Page 25