LG GT-279WDC Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
INSTALLATION
SELECT A GOOD LOCATION
NEXT
1. Place your refrigerator where it is easy to use.
1. Wipe off all dust accumulated during shipping
and clean your refrigerator thoroughly.
2. Install accessories such as the ice cube box,
evaporating tray cover, etc., in their proper
places. They are packed together to prevent
possible damage during shipping.
3. Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances
on the same outlet.
4. Prior to use, let the refrigerator run for 3-4
hours. Check the flow of cold air in the freezer
compartment to ensure proper cooling has
taken place.Your refrigerator is now ready for
use.
THIS REFRIGERATOR IS MANUFACTURED WITH GREAT CARE AND UTILIZES THE
LATEST IN TECHNOLOGY.
WE ARE CONFIDENT THAT YOU WILL BE FULLY SATISFIED WITH ITS PERFORMANCE
AND RELIABILITY.
BEFORE USING YOUR REFRIGERATOR, PLEASE READ THIS BOOKLET CAREFULLY.
IT PROVIDES EXACT INSTRUCTIONS FOR INSTALLATION, OPERATION, AND
MAINTENANCE, AND ALSO SUPPLIES SOME USEFUL HINTS.
10
3. Air must circulate properly around your
refrigerator to ensure efficient operation.
If your refrigerator is placed in a recessed area
in the wall, allow at least 10 inches (25 cm) or
greater clearance above the refrigerator and 2
inches (5 cm) or more from the wall.
The refrigerator should be elevated 1 inch
(2.5 cm) from the floor, especially if the floor is
carpeted.
2.
Avoid placing the unit near or next to heat
sources, direct sunlight or moisture.
Do not install the refrigerator in an open or
sheltered outdoor environment.
4.
To avoid vibrations, the unit must be level.
If required, adjust the leveling screws to
compensate for unevenness of the floor.
The front should be slightly higher than the
rear to aid in door closing.
The front leveling screws can be turned easily
by tipping the cabinet slightly.
Turn the leveling screws clockwise( ) to
raise the unit, counterclockwise( ) to
lower it.
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire